Solução de problemas de emendas por fusão
A fusion splice is when two fibers are fused together using an electric arc. Often used with pigtails for connecting 250-micron outside plant fiber to 900-micron inside plant fiber at the building entrance, fusion splicing is achieved with a fusion splicing machine after the fiber is properly cleaved with a precision cleaver. Fusion splicing can be done for a single fiber or for 12-fiber ribbon cable via mass fusion splicing that splices all 12 fibers at once.
Fusion splicing provides the lowest loss and least reflectance, and is considered the strongest and most reliable method of joining two fibers. When properly executed, a splice can exhibit a loss of less than 0.1dB. Let’s take a closer look at some considerations with locating and troubleshooting these high performing connection points.
I Can’t Locate My Splice!
With such a low loss and without the reflection you get with connectors, quality splices simply might not show up when using your OptiFiber™ Pro OTDR. But what if for some reason you actually want to locate a fusion splice, even a good quality one?
With a few simple adjustments to your settings using the Manual OTDR option, it’s quite easy. First, you may need to set your Loss Threshold on the OptiFiber Pro to locate events that have a loss less than 0.1dB. The OptiFiber Pro Auto setting for Loss Threshold is 0.15dB, which means it will only find events at or above this level. However, the Loss Threshold can be user defined from 0,01 to 1.50dB.
Note que valores de limites menores significam que o testador executará mais medições ou usará larguras de pulso maiores, o que pode aumentar os tempos de teste ou zonas mortas no traço. A Loss Threshold of less than 0.15dB may also cause the OTDR to find false events due to inherent imperfections in the fiber.
Alterar o tempo médio também pode ajudar a localizar emendas por fusão. Averaging Time sets the number of measurements averaged together to create the final trace – longer times reduce noise to reveal more details like non-reflective splice events.
Como você usará o Versiv?
Identifying the Problem
With a good quality cleave and a fusion splice machine, it’s easy to achieve a proper splice. However, if the splices and slack are placed into the splice tray without properly following the tray’s cable guides, it could result in exceeding the bend radius of the fiber.
To locate this type of stress, you may need to test at two wavelengths – 850 and 1300nm for multimode and 1310 and 1550 for singlemode. At the higher wavelength, a stressed fiber will show significantly higher loss while normally the higher wavelength would show a lower loss. You may also need a VFL to determine if the problem is a cracked or kinked fiber rather than the pigtail connector as the event on the trace will typically show up at about the distance to the connector.
It’s also important to do bidirectional testing. If there is a backscatter mismatch between the pigtail fiber and the fiber it is being spliced to, it will look like a gainer (i.e., negative loss) in one direction and too much loss (i.e., false loss) in the other direction. If the test is done from both directions and the loss is averaged, the result is the actual loss.
To make bidirectional testing easy, the OptiFiber® Pro features a built-in “SmartLoop OTDR" Assistant that uses a loop at the remote end of a duplex fiber link, allowing you to test in both directions from one end. It also features on-board averaging of the two measurements to provide an accurate final loss measurement.