Blog: Crônicas sobre cabeamento | Page 5 | Fluke Networks

Blog

Crônicas sobre cabeamento

19-9-2018

Uma indústria de inovadores

Last week at the 2018 BICSI Fall Conference in San Antonio, TX, two of Fluke Networks’ solutions were chosen by a panel of top-tier cabling and communications systems specifiers, designers, integrators and managers for making groundbreaking contributions to the structured cabling industry.

11-9-2018

O A-B-C da polaridade da fibra

Polarity defines direction of flow, such as the direction of a magnetic field or an electrical current. In fiber optics, it's The A-B-C’s of Fiber Polarity

To properly send data via light signals, a fiber optic link’s transmit signal (Tx) at one end of the cable must match the corresponding receiver (Rx) at the other end.

08-9-2018

Muito para aprender (e CECs também) na BICSI Fall Conference & Exhibition da próxima semana

At the upcoming BICSI Fall Conference & Exhibition on September 9 – 13 at the Henry B. Gonzáles Convention Center, San Antonio, TX, there are plenty of opportunities to learn about the latest technologies, and Fluke Networks is excited to bring you the latest on testing everything from advanced four-pair PoE to passive optical networks (PONs).

How does Your Fiber Design and Installation Stack Up?

06-9-2018

Teste do diagrama de fios: não é somente a cor

A wire map test may seem like the most basic test for copper network cabling and therefore one of the least important, but it is actually one of the most critical. And while the pair colors of blue, orange, green and brown might help you pass wire map testing, the test itself really doesn’t care about color at all.

Let’s take a closer look.

What’s It Testing For?

15-8-2018

O caminho para 200 e 400 Gig já está pavimentado (e percorrido)

The increasing demand for higher bandwidth to support Big Data has driven the need for ever-increasing Ethernet speeds, starting with 10 Gig in 2004 to the introduction in 2010 of 40 Gig with 4 fibers transmitting and 4 fibers receiving at 10 Gbps (40GBASE-SR4) and 100 Gig with 10 fibers transmitting and 10 fibers receiving at 10 Gbps (100GBASE-SR10).

02-8-2018

Troubleshooting Installed Cable with DSX-5000 CableAnalyzer

It felt like a Monday morning when the call, actually an e-mail, came in. “I think my DSX is broken!” As you know, they are really tough machines and, when it looks like the Fluke is wrong, usually it isn’t.

“What makes you think it is broken?” I asked, “How does this failure manifest itself?”

“The tester is failing links that used to pass.”

01-8-2018

Por que eu recebo "perda positiva" ao verificar um cabo de teste?

Verification of test reference cords is easy, right? Yes, usually…but not always. After the power meter is set to 0 dB via the reference procedure, the loss of a mated connector pair is expected to be less than 0,20 dB for single-mode (e.g., -0,20 dB). Let’s examine one scenario where a loss is not negative (e.g., +0,15 dB).

The typical process for validating the loss of a connector, to verify if it is “reference grade” for example, is as follows:

25-7-2018

Testes nos espaços do Data Center

Depending in which functional area of the data center you are testing, there are different applications, cabling and connectivity that you will encounter. Understanding the functional areas of the data center and what you will likely need to test in each can help prepare you for data center testing.

What Are the Spaces?

Páginas

 
 
Powered By OneLink