Bi-directional Testing with Light Source and Power Meter


Voltar para todos os blogs

Em testes bi-direcionais, com uma fonte de luz e medidor de energia

Seymour Goldstein

In the 2014 version of ISO/IEC 14763-3, testing of optical fiber cabling, unidirectional testing for permanent links is required. In specific cases, bi-directional testing is required. However, ISO/IEC 14763-3 provides no information on how a bi-directional test should be done - this article explains how.

When Bi-Directional Testing is Required

Per ISO/IEC 14763-3, if the link comprises a single fixed cable and terminating connectors, a unidirectional testing may be performed. If the link or channel is more complex, or where there is risk that components within the cabling under test cause differences in the attenuation depending on the direction of transmission, bi-directional measurements shall be carried out.

Bi-Directional Testing with a Light Source and Power Meter

1)   Set a reference with a reference grade launch cord using the 1-cord method (see Figure 1).

Set a reference w/reference grade launch cord using 1-cord method
Figura 1. Set a reference.

2)   Verify low loss at the connector pair B-C between the launch cord and receive cord (see Figure 2).

Verify loss at connector pair B-C between launch and receive
Figura 2. Verify test cords for low loss

3)   Test in one direction. Do not disconnect the launch cord from the light source. Attach the launch cord to one end of the cabling and the receive cord and power meter to the other end of the cabling (see Figure 3).

Test in one direction. Don’t disconnect launch-cord from light source.
Figura 3. Test permanent link in the X-Y direction

4)   Then, without disconnecting the launch cord from the light source, move to connection Y. Move the receive cord and power meter to connection X (see Figure 4).

Without disconnecting launch cord from source, move to connection Y
Figura 4. Test permanent link in the Y-X direction

Obs.: Use the worst of the two measurements as the final test result. If the difference in the two measurements is greater than 0,2 dB, the reference could be wrong, something may be wrong with the test cord, or there may be a bend in the fiber.

Bi-Directional Testing with an Optical Loss Test Set

If using an optical loss test set (OLTS) containing a power meter and light source in one box, simply swap the connections after the test is run at the patch panel or fiber distribution center, being careful to maintain the mated connections to the test equipment (see Figure 5 and 6).

Using OLTS swap connections after the test at patch panel
Figura 5. Test permanent link in the Y-X and W-Z direction

Using OLTS: be careful to maintain mated connections to equipment
Figura 6. Test permanent link in the X-Y and Z-W direction

Regardless of the type of equipment, the key thing to remember is to NOT disconnect the launch or receive cord from the tester once you’ve set the reference and verified the launch and receive cords. Doing so can add significant uncertainty to your measurements.

Usually, bi-directional testing is needed when testing a permanent link with an OTDR. But for some specific link configurations, it may be needed when using a light source and power meter. In that case, the method outlined in this article should be used. Who knows, maybe ISO/IEC 14763-3 will adopt this method in its next revision cycle.

Powered By OneLink