Blog: Crônicas sobre cabeamento | Page 2 | www.flukenetworks.com

Crônicas sobre cabeamento

2017-08-09

In the 2014 version of ISO/IEC 14763-3, testing of optical fiber cabling, unidirectional testing for permanent links is required. In specific cases, bi-directional testing is required. However, ISO/IEC 14763-3 provides no information on how a bi-directional test should be done - this article explains how.

When Bi-Directional Testing is Required

2017-08-02

Testing and characterizing a permanent link with an OTDR requires the measurement of connector attenuations A/B and fiber loss C. To make this measurement, a launch and tail cord are needed (see Figure 1).

2017-07-05

Polarity defines direction of flow, such as the direction of a magnetic field or an electrical current. In fiber optics, it defines the direction that light signals travels through an optical fiber.

To properly send data via light signals, a fiber optic link’s transmit signal (Tx) at one end of the cable must match the corresponding receiver (Rx) at the other end.

2017-06-29

While it may look and feel like a fiber patch cord, Test Reference Cords, or TRCs for short, are not patch cords. There’s a little something different about these cords that are used for certifying fiber cabling systems to ANSI/TIA, ISO/IEC and IEEE standards.

2017-06-21

Recently we have been getting questions about how to determine if an SFP is working. I’m going to use SFP generically here to represent a multitude of the various optical modules that are available. The Fluke Networks fiber testers can be used to measure the light that is being put out by and SFP.

2017-06-14

By now you’ve probably heard of 8-fiber MPO plug and play solutions available on the market, which are ideal for Gigabit (40GBASE-SR4) and 100 Gigabit (100GBASE-SR4) applications that use 8 fibers with 4 transmitting and 4 receiving at either 10 or 25 Gb/s.

2017-06-07

We’ve just posted Version 5,1 Build 4 of the Versiv software for the following products:

2017-05-31

Maybe you’ve seen TCL and ELTCTL listed on your cable spec sheet, or perhaps you’ve noticed them on your DSX CableAnalyzer, and you’re simply not familiar with these parameters, what they indicate and if they are required. Let’s take a closer look.

What is Mode Conversion?

Páginas

 
 
Powered By OneLink