Setting the number of connectors/adapters & splices - OMNIFiber | Fluke Networks

Base de conhecimento

KB Home   >  Teste de fibra   >  OMNIFiber®

Setting the number of connectors/adapters & splices - OMNIFiber

The last PentaScanner left the factory back on 31 de março de 2004. We regret to say support ended 31 de março de 2008. It's replaced by the Versiv familly of testers

It is not in the SETUP menus. Once you have completed your reference measurement, press AUTOTEST. You will then be presented with the following screen.

Setting Number of Connectors

Press ENTER to change the number. Once done, press key 1 Next Key to run the Autotest.

Autor: Fluke Networks

Data de criação: 03-4-2014

Última alteração: 03-4-2014

 
 
 
 
Powered By OneLink