How do I set the Omniscanner to test Category 3 | Fluke Networks

Base de conhecimento

KB Home   >  Teste de cobre   >  OMNIScanner™

How do I set the Omniscanner to test Category 3

The last OMNIScanner left the factory back in July 2005. We regret to say service and support ended July 2009. It's replaced by the Versiv familly of testers.
 
From the Main screen of the OMNIScanner go into the Setup Screen. Highlight AUTOTESTS and then press ENTER.  

 
  

Highlight the TIA folder and press ENTER.
 
 
  

Scroll down the list until you see the Cat3 Autotests. Highlight the Autotest that you want to run and then press the Set Default Key (the arrow on soft key F2). Press ESC to retrun to the Setup Screen.
 
 
  

Highlight the CABLES menu item and press Enter.
 
 
  

Select the Generic Cables Folder and press ENTER.

 
  

Select the Cat 3 UTP from the list and then press the Set Default Key (the arrow on soft key F2). Press ESC to return to the Setup Screen. Press ESC again to return to the Main Screen. The OMNIScanner is now ready to test Category 3 Cabling.
 
 
  
 
 

Author: Adrian Young

Creation Date: 2014-02-27

Last Modified: 2014-02-27

 
 
 
 
Powered By OneLink