Deleting Autotest results from the OMNIScanner | Fluke Networks

Base de conhecimento

KB Home   >  Teste de cobre   >  OMNIScanner™

Deleting Autotest results from the OMNIScanner

The last OMNIScanner left the factory back in July 2005. We regret to say service and support ended July 2009. It's replaced by the Versiv familly of testers.
 
There are two ways to delete results from the internal memory of the OMNIScanner. They can be deleted by Project or deleted one test result at a time.
 
To delete the results from an entire Project, press the Results Key Results Key in OMNIScannerfrom the Main screen of the OMNIScanner.
 
Highlighted Project Name Screen
 
On the Results screen, highlight the Project that you want to delete all the results from. Press the Delete Key Delete Key in OMNIScannerto delete all the Autotest results from the Project. The OMNIScanner will prompt you to verify that you want to delete the results from the OMNIScanner. Select YES to delete all results in the Project
 
Highlighted Project on result ScreenDelete Results Confirmation Message
 
 
To delete one test at a time, press the Results Key Results Key in OMNIScannerfrom the Main screen of the OMNIScanner.
 
Main Screen of the OMNIScanner
 
On the Results Screen, highlight the Project that you want to delete results from and then press Enter. Highlight the Autotest result that needs to be deleted and press the Delete Key Delete Key in OMNIScanner.

The OMNIScanner will delete the Autotest Result without any other prompts. Be careful deleting from this screen. If a result is deleted from here, the result will not be able to be recovered.

 
Highlighted Project on result ScreenHighlight Autotest Result 

Author: Adrian Young

Creation Date: 2014-02-26

Last Modified: 2014-02-26

 
 
 
 
Powered By OneLink